Cabletron Systems BRIM E100 BRIM-E100 - Manual (Page 37)

Chapter 5: Local Management
Page 5-6 BRIM-E100 User’s Guide
2. Use the LEFT-ARROW key to move back to the Advertised Ability
selection and use the SPACE bar to select the next mode you wish to
enable or disable. Use the RIGHT-ARROW key to move across to the
Enable/Disable field to the right of the selection. Use the SPACE bar
to select Enable or Disable. Press ENTER. Continue this process until
you have completed enabling or disabling the advertised modes.
3. Use the ARROW keys to highlight the SAVE command. Press
ENTER. The message “Save Done!” appears and Local Management
saves the changes to memory.
5.3.2 FE-100FX Configuration
This section provides instructions for manually configuring the
BRIM-E100 with an FE-100FX Fast Ethernet Interface Module installed.
The BRIM-E100 Setup screen (see Figure 5-1) must be accessed through
Local Management before proceeding with the following steps.
Desired Operational Mode
Use this field to set the active technology. This field toggles between
100Base-FX and 100Base-FXFD (full duplex). Use the following steps to
set the active technology:
1. Use the ARROW keys to highlight Desired Operational Mode and
use the SPACE bar to select 100Base-FX or 100Base-FXFD (full
duplex). Press ENTER. The BRIM-E100 now operates in the chosen
mode.
2. Use the ARROW keys to highlight the SAVE command. Press
ENTER. The message “Save Done!” appears and Local Management
saves the changes to memory.
book Page 6 Friday, April 19, 1996 9:53 AM