2 installing fast ethernet interface 3.2 modules, Installing fast ethernet interface modules -2, 2 installing fast ethernet interface modules – Cabletron Systems BRIM E100 BRIM-E100 User Manual
Page 19
Advertising
Chapter 3: Installation
Page 3-2
BRIM-E100 User’s Guide
3.2 INSTALLING FAST ETHERNET INTERFACE
MODULES
Install a Fast Ethernet Interface Module into the BRIM-E100 as follows:
1. Attach the disposable grounding strap to your wrist and to a proper
ground. Refer to the instructions outlined on the disposable grounding
strap package.
2. Remove the screws securing the Fast Ethernet Interface Module
coverplate to the standoffs on the BRIM-E100 and remove the
coverplate from the BRIM-E100 (see Figure 3-1).
3. Remove the screw from the top of the standoff at the rear of the
BRIM-E100.
Figure 3-1
Removing the Coverplate on the BRIM-E100
COVERPLATE
166509
STANDOFF
TX
RX
BRIM-E100
book Page 2 Friday, April 19, 1996 9:53 AM
Advertising