Cisco OL-15491-01 - Manual (Page 212)

A-212
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
parse length
parse length
To define the maximum number of Layer 7 bytes that the CSG2 is to parse when attempting to assign a
policy, use the parse length command in CSG2 content configuration mode. To restore the default
setting, use the no form of this command.
parse length number
no parse length
Syntax Description
Defaults The CSG2 parses up to 4000 Layer 7 bytes when attempting to assign a policy.
Command Modes CSG2 content configuration
Command History
Usage Guidelines If the parse length is exceeded, the CSG2 blocks or forwards packets on the basis of the block command.
This command is valid only if parse protocol http is also configured.
Examples The following example specifies that the CSG2 is to parse up to 1234 Layer 7 bytes when attempting to
assign a policy:
ip csg content MOVIES
parse protocol http
parse length 1234
Related Commands
number Maximum number of Layer 7 bytes to parse. The range is from 1 to 65535.
The default value is 4000.
Release Modification
12.4(11)MD This command was introduced.
Command Description
block Forces the CSG2 to drop packets that do not match a configured billing
policy.
ip csg content Configures content for CSG2 services, and enters CSG2 content
configuration mode.
parse protocol Defines how the CSG2 is to parse traffic for a content.