Juniper Systems Allegro 2 Quick Start - Manual

1 Loosen the 4 captive screws on the battery door with a #1 Phillips screwdriver. Remove the door.
CAUTION: The handheld is not sealed when the door is removed.
2 Place the battery pack into the compartment. Be sure to line up the and .
3 Replace the battery door and tighten the screws.
4 Slide the correct plug for your location onto the AC power charger. Plug the charger into a wall socket and
the DC connector on the handheld.
5 The handheld powers on and several screens appear. When the Update Time screen is shown make
adjustments if needed and select OK.
6 Charge the battery pack at room temperature for 5 hours.
The operating system, manual and quick start guide is available in English, Spanish, French, German,
and Brazilian Portuguese. Go to our website at www.junipersys.com/Allegro-2/support.
© 2014 Juniper Systems, Inc. All rights reserved. Allegro 2 is a trademark of Juniper Systems, Inc. Part Number: 24538-00
Battery Door
Screws
9-pin Serial Port
Microphone/Speaker Jack
USB Client
Handstrap Attachment Point
Camera Lens (option)
USB Host
Docking Pin Contacts
12-24 VDC Connector
Indicator LEDs
QWERTY Keys
Microphone
Battery Pack SIM & SD Card Slots
Touchscreen
Camera Flash/Flashlight (option)
Bumper Stylus Tether Attachment Point
Numeric Keys
Handstrap
& Stylus
Power Button
Speaker
Start Here
Expansion Door
Handstrap Attachment Points
To view the Orange Power User Key menu press the orange + F1 keys.