Juniper Systems Mesa Addendum - Manual

Non-incendive Approval
The non-incendive Mesa
Rugged Notepad™ from
Juniper Systems, Inc. is
MET Laboratory approved
Non-Incendive Class I Div 2
per approval standard UL
1604 CSA 213 in the U.S. and
Canada.
The non-incendive Mesa may be used
in hazardous locations where ignitable
concentrations of flammable gases,
vapors or liquids are not part of the normal
environment but can become so under
unusual circumstances.
Model MSA Series
Electrical Rating +12VDC, 1.5A
Battery Type
Li-Ion ( only use the
batteries specified
in the Mesa Owner’s
Manual, P/N 20545)
Class, Division,
Groups
Class I Division 2
Groups A, B, C, D T4
Read This Document
Read this document to learn how to safely
operate the non-incendive Mesa Rugged
Notepad in potentially
hazardous locations.
This addendum is a
supplement to the
owner’s manual that
came with the Mesa.
Refer to the owner’s
manual for details on
how to use the Mesa.
Note: The Mesa Owner’s
Manual is also available
on our website at www.junipersys.com.
Non-incendive Mesa Rugged Notepad
P/N 23339-00. Copyright December 2011, Juniper
Systems, Inc. All rights reserved. Information is
subject to change without notice. Mesa Rugged
Notepad is a trademark of Juniper Systems, Inc.
tel: 435.753.1881 l web: www.junipersys.com
1132 W. 1700 N. Logan, UT 84321
Using the Mesa Rugged Notepad
in a Hazardous Location
The following rules must be followed to
maintain the MET Laboratory approved
non-incendive standard and to prevent the
possibility of serious injury.
Warning: Explosion hazard – In
hazardous locations:
„
Do not dock the Mesa
„
Do not change or charge batteries
„
Do not insert or remove cards
„
Do not connect or disconnect any
device or cable
In hazardous locations the connector
protector and battery doors must be in
place as indicated below:
Avertissement : risque d’explosion –
Dans des zones dangereuses:
„
N’amarrez pas l’unité, ne changez pas et
ne chargez pas les batteries, n’insérez et
ne retirez pas de cartes et n’établissez ni
ne rompez aucune connexion
„
Les caches de protection des ports et
des batteries doivent toujours rester
installés
E113334