Juniper Systems Field PC Cap Replacement - Manual

Field PC Cap Replacement
Instructions
These are instruction on replacing the Field
PC’s top and bottom caps.
Included in this packet:
· Top cap
· 2 top cap screws (large)
· Bottom cap
· 4 bottom cap screws (small)
1. Use a screwdriver to remove the two
screws located at the top of the Field PC.
Remove top cap.
2. Use a screwdriver to remove four
screws, two on each side. Remove
bottom cap.
3. Place new bottom cap on Field PC and
use the four new screws (small), two on
each side, to attach cap.
4. Slide new top cap onto unit, make sure
side tabs fit in bottom cap, and use the
two (large) screws to attach cap.
P/N 22395-00 05/09
Field PC Cap Replacement
Instructions
These are instruction on replacing the Field
PC’s top and bottom caps.
Included in this packet:
· Top cap
· 2 top cap screws (large)
· Bottom cap
· 4 bottom cap screws (small)
1. Use a screwdriver to remove the two
screws located at the top of the Field PC.
Remove top cap.
2. Use a screwdriver to remove four
screws, two on each side. Remove
bottom cap.
3. Place new bottom cap on Field PC and
use the four new screws (small), two on
each side, to attach cap.
4. Slide new top cap onto unit, make sure
side tabs fit in bottom cap, and use the
two (large) screws to attach cap.
P/N 22395-00 05/09
Field PC Cap Replacement
Instructions
These are instruction on replacing the Field
PC’s top and bottom caps.
Included in this packet:
· Top cap
· 2 top cap screws (large)
· Bottom cap
· 4 bottom cap screws (small)
1. Use a screwdriver to remove the two
screws located at the top of the Field PC.
Remove top cap.
2. Use a screwdriver to remove four
screws, two on each side. Remove
bottom cap.
3. Place new bottom cap on Field PC and
use the four new screws (small), two on
each side, to attach cap.
4. Slide new top cap onto unit, make sure
side tabs fit in bottom cap, and use the
two (large) screws to attach cap.
P/N 22395-00 05/09
Field PC Cap Replacement
Instructions
These are instruction on replacing the Field
PC’s top and bottom caps.
Included in this packet:
· Top cap
· 2 top cap screws (large)
· Bottom cap
· 4 bottom cap screws (small)
1. Use a screwdriver to remove the two
screws located at the top of the Field PC.
Remove top cap.
2. Use a screwdriver to remove four
screws, two on each side. Remove
bottom cap.
3. Place new bottom cap on Field PC and
use the four new screws (small), two on
each side, to attach cap.
4. Slide new top cap onto unit, make sure
side tabs fit in bottom cap, and use the
two (large) screws to attach cap.
P/N 22395-00 05/09