Juniper Systems Handstrap kit Archer 2 - Manual

tel: 435.753.1881 l web: www.junipersys.com
1132 W. 1700 N. Logan, UT 84321
handstrap kit
replacement instructions
Contents of Hand Strap Replacement
Kit:
„
One Archer2 hand strap
„
Instruction sheet
Tools required
„
Scissors
„
Small needle-nosed pliers
Removing the hand strap
1. Remove the top bumper from the
Archer2.
2. Remove the hand strap from the
Archer2 by cutting the old strap on both
sides of the stylus holder.
3. Pull the cut hand strap through the
latches on the top and bottom of the
Archer2.
Installing the new hand strap
1. Place the new hand strap on top of the
Archer2 with the loop of the stylus holder
pointing toward the Juniper logo.
2. Flip the hand strap lengthwise toward
the top of the Archer2.
3. Push the sewn end of the hand strap into
the top latch of the Archer2.
4. Once the end is through the latch, pull
the end through the latch with the pliers.
5. Pull the hand strap back through the
latch to seat the strap in the latch.
6. Position the battery door above the
Archer2 so that the open side faces the
Archer2 and the latch facing up.
7. Insert the other sewn end of the hand
strap into the latch of the battery door.
8. Pull the end through the strap with the
needle-nosed pliers.
9. Pull the hand strap back through the
latch to seat the strap in the latch.
10. Flip the battery door over the Archer2
and secure the door in place.
11. Replace the top bumper.
12. For additional instructions, visit http://
www.junipersys.com/Juniper-Systems-
Rugged-Handheld-Computers/
products/Archer-2/Videos.
P/N: 24074.00 Copyright December 2013, Juniper Systems,
Inc. Information is subject to change without notice. Juniper
Systems and Archer2 are trademarks of Juniper Systems, Inc.