Juniper Systems Allegro CX Quick Start - Manual

Before you begin using your Allegro CX
Complete all of the steps outlined in each section of this guide.
Installing the battery pack into the Allegro
Before turning on the Allegro, the battery pack must be installed.
To do this, complete the following steps:
Push up the release latches on the
sides of the Allegro to open the
battery compartment door.
Place the NiMH battery pack in the
left side of the battery compartment,
push down, and slide it to the right.
Push the battery door closed until
each release latch clicks into place.
Slide the release latches downward
until they cannot slide any further to
securely latch the battery door closed.
Do not turn on the Allegro yet.
Plug the AC wall charger that came
with the Allegro into the wall socket.
Remove the rubber protector from
the Allegro’s external power input
jack.
Plug the power connector end of the
AC wall charger into the Allegro. The
Allegro turns on automatically.
The Windows CE .NET operating
system loads onto the Allegro, a
progress bar appears. No action
is required until the New Battery
Detected screen appears.
1)
2)
3)
4)
5)
6)
7)
Q
UICK
S
TART
G
UIDE