Juniper Systems I/O module Archer 2 - Manual

tel: 435.753.1881 l web: www.junipersys.com
1132 W. 1700 N. Logan, UT 84321
I/O module
replacement instructions
Contents of I/O Module Replacement Kit
„
The Archer 2 I/O Module replacement kit
includes the following items:
„
Archer 2 I/O module
„
Two replacement M2X6 screws
„
Screwdriver
Removing the I/O module
1. Remove the bottom bumper.
2. Using the provided screwdriver, loosen four
screws to remove the battery door.
3. Remove the battery.
4. Remove the two screws from the sides of
the module. See Figure 1.
5. Carefully pull straight back to remove the
module from the Archer 2.
Installing the new I/O module
1. Inspect new module to ensure that the
pins that go into the Archer 2 are straight
and that the rubber gasket around the
pins is in place as shown. See Figure 2.
CAUTION: if the pins are not straight, do not
attempt to straighten them or use the module.
Contact a service center for a replacement
2. Place the tabs of the new module in the
grooves of the case. See Figure 3.
P/N: 24077.02 Copyright June 2014, Juniper Systems, Inc.
Information is subject to change without notice. Juniper
Systems and Archer 2 are trademarks of Juniper Systems, Inc.
3. Align the pins with the black connector on
the main board using a slight side-to-side
rocking motion.
4. Firmly push down on board above the
pins as shown, NOT on the plastic. See
Figure 4. Push until the pins seat in the
connector and there is no gap between
the module and the Archer 2.
CAUTION: If the module does not push
in with firm pressure, STOP. Remove the
module and re-inspect the pins to ensure
they are not damaged.
5. Insert two provided M2X6 screws into the
marked holes.
6. Tighten screws with the provided
screwdriver. Ensure they are snug, but
do not force them.
7. Replace the battery door.
8. Replace the bumper.
9.
For additional instructions, visit http://
www.junipersys.com/Juniper-Systems-
Rugged-Handheld-Computers/
products/Archer-2/Videos.
Grooves in case
Tabs on module
Figure 1
Figure 2
Figure 4
Figure 3
These instructions are used with the following kits:
24078 AR2 Communication Module Replacement Kit
24201 AR2 Docking Module Replacement Kit
24389 Measurement Specialties 12-volt Module Kit
Note: 24078 kit shown. Modules may differ in appearance