Operating instructions – Vermont Casting 36CDVTRN User Manual

Page 28

Advertising
background image

28

CDV Series Direct Vent Gas Fireplace

20010175

Only glass approved by CFM Corporation
should be used on this fireplace.

The top louvre panel
is removed by lifting
the panel vertically and
pulling it away from the
appliance. (Fig. 56) The
lower access door is
removed in the same
manner.

1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the

components to cool.

3. Remove the top louvre assembly.
4. Remove the lower louvre panel.
5. Release the two clamps securing the lower edge of

the window frame assembly by pulling down on the

handles. (Fig. 57)

6. Tilt the window frame assembly out slightly at the

bottom, lift the window frame assembly up and away

from the fireplace.

7. To replace the window frame assembly reverse

the procedure.

It is necessary to periodically clean glass. During start-
up condensation, which is normal, forms on the inside
of the glass. This condensation causes lint, dust and
other airborne particles to cling to glass surface.
Also initial paint curing may deposit a slight film on
the glass. It is therefore recommended the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas fireplace glass cleaner) within the first few weeks of
operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.

The use of any non-approved replacement glass will
void all product warranties.

Care must be taken to avoid breakage of the glass.

Do not operate appliance with glass front
removed, cracked or broken.

Replacement glass (complete with gasket) is
available through your CFM Corporation dealer
and should only be installed by a licensed
qualified service person.

Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.

Operating Instructions

Glass Information

Window Frame Assembly Removal

Glass Cleaning

Louvre Removal

1.

2.

FP1601

Louvre removal

12/05

Louvre

Glass Panel

FP1602

Fig. 56 Remove top louvre
assembly.

FP1228

remove glass frame

11/02

Lower Clamps

Window

Frame

Assembly

Push

Clamp

Handle

Pull Clamp

Hook

Window

Frame

Assembly

FP1228

Fig. 57 Window frame assembly removal.

Advertising