Kenton Pro-2000 mk1 - Manual (Page 10)

9
AUXILIARY OUTPUTS
THE FOLLOWING PARAMETERS ARE THE SAME FOR EACH AUXILIARY 1 TO 6
(where x is the auxiliary number)
AUX x AUX OUTPUT x Receive channel(1to16, default: 1 to 6 set to 1 to 6
respectively)
- assigns the auxialiary to which ever MIDI channel you wish to set it to, i.e. to get the auxiliary to
respond the synth on CV channel A, set it to the same receive channel as that synth.
AUX x CONTROLLER (pb, vel, aft, controllers 1-119, V/Oct form Notes, Gate from
Notes, Trig pulse A/B - default: #16 general purpose controller)
- sets the MIDI controller source to control the analogue auxiliary output level, to control VCF, VCA
etc.
see below for details of the new modes V/Oct, Gate & Trig A/B.
AUX x OUTPUT LEVEL For cntrl Min (-64 to +64, default: 0)
- sets the auxiliary output level for when the MIDI Controller Source is at its minimum.
AUX x OUTPUT LEVEL For cntrl Max (-64 to +64, default: 64)
- sets the auxiliary output level for when the MIDI Controller Source is at its maximum.
AUX x OUTPUT LEVEL Reset Level
(-64 to +64, default: 0)
- sets the level that the auxiliary will reset to when a MIDI reset command is received.
AUX x LFO DEPTH CONTROLLER (pb, vel, aft, controllers 1-119, default: #17)
- sets the MIDI controller source to control the LFO depth that will modulate the auxiliary output.
AUX x LFO DEPTH AMOUNT For cntrl Max (0-127 default: 63)
- sets the depth of the LFO at the controller maximum.
AUX x LFO ASSIGN Use LFO number (1 to 2, default: 1-3=1, 4-6=2.)
- lets you assign which of the two inbuilt LFOs will modulate the auxiliary
NEW MODES FOR AUX CHANNELS 1-6
V/Oct from Notes
- this allows the selected auxiliary output to give a CV voltage to control the CV input of a synth. Set
the MIDI receive channel of the selected auxiliary and use in conjunction with another Aux set to
the
same channel but configured as a gate (see below). The MIDI channel can be any channel you
want, for any aux, it is independent of Channels A/B.
You can modulate the output using an LFO but the range default is set to be appropriate for its use
as an Aux out - we suggest you set the LFO Depth Amount to 10 or so (and probably set the
controller for it to #1 (Mod Wheel))
When using this mode, the Min value becomes the Fine-tune value, the Max value becomes Scale
and you should ensure the reset value is 0. When you want to tune the converter to your synth, first
play C note #36 (usually the bottom note on a 61 note keyboard) and use fine tune to get that right,
then play C a couple of octaves up and get that in tune using the scale adjustment. Restrictions - The
Aux outputs cannot be set to Hz/V mode, there is no portamento, sustain pedal or transpose facility,
note memory is for 2 notes only, note priority is for most recent note in multiple trigger mode.