Kenton Pro-2000 mk1 - Manual (Page 7)

6
PARAMETERS
THE FOLLOWING PARAMETERS ARE THE SAME FOR BOTH OF THE CV
CHANNELS, A, B (where x is the channel)
CV x SYNTH CHANNEL x (1 to 16, defaults: A=1 B=2)
- sets the MIDI receive channel for PRO-2000 analogue channel.
CV x NOTE PRIORITY
(low/high/newest, default: newest)
- sets the note priority.
If set to "Lowest" then the new note played takes precedence if it is lower than the preceding note.
If set to "Highest" then the new note played takes precedence if it is higher than the preceding note.
If set to "Newest" then the newest played note played takes precedence regardless.
CV x TRIGGER MODE (Single/Multiple, default: Multiple)
- sets the whether the envelope on your synth will be retriggered when a new, overlapping note is
played. If set to "Single," then the Gate output will stay on, or the trigger (if selected) will not re-
trigger when a new note is played, if you are playing in a legato fashion, with notes overlapping.
If set to "Multiple," then the Gate (or S-Trig) output will re-Gate each time a new note is played, re-
triggering your synth`s envelope generators, regardless of your playing style.
CV x TRANSPOSE (-24 to +24 semitones, default: 0)
- allows you to Transpose the incoming MIDI notes in semitone steps. You can adjust this in real-time,
allowing you to hear the changes you make to Transpose, without having to re-play a key.
CV x PITCHBEND (0 to 24 semitones, default: 2)
- sets the maximum range the pitchbend will bend the CV output.
CV x PORTAMENTO RATE (0 to 127, default: 98)
- sets the speed at which portamento glides between notes. Note that 0 is fastest rate but does not
mean portamento off, use portamento controller (below) for that! This value can also be varied in
real time using MIDI controller number 5 (portamento time). If this parameter is in view on the
display, its new value will not be displayed when varied using controller 5. However If varied via
SYSEX, the new value will be displayed.
CV x PORTAMENTO CONTROLLER
(ON, OFF, 0-119, default: 65)
- sets the controller responsible for enabling-disabling the portamento control. If on or off are selected
these force on or off.