Kenton Pro-2000 mk1 - Manual (Page 4)

3
FRONT PANEL
Each channel, A and B, has LED indicators to indicate when that channel`s Gate is on.
There are three more LED status indicators;
One is marked DATA. This illuminates when the PRO-2000 is receiving MIDI data.
The other two are marked PARAMETER and VALUE. These indicate which mode the PRO-2000 is in,
and are toggled by the SELECT button.
Four buttons; SELECT, ENTER and INC and DEC. - These are for editing the PRO-2000.
* INC and DEC - scroll through parameters or values, depending on which mode the unit is in.
* SELECT - (1) toggles between Parameter and Value for editing. (2) If you hold in the SEL button for a
couple of seconds it will take you directly to the STORE or LOAD page. If something has been edited
it will take you straight to STORE otherwise it take you to LOAD. It just takes you to the page - you still
need to select the correct memory location and press Enter to perform the operation.
*ENTER - this button has 3 functions - (1) It displays the memory number from which the setup has
been loaded, and whether or not it has been edited. (2) When in system settings mode (LOAD from
or STORE to) this button will save the settings which you have entered. (3) If you hold the button in
for about 6 seconds it will perform a global all notes off and display a message to that effect on the
display. (NB this turns off all notes on the PRO-2000, it does not send any MIDI messages out of the
MIDI out port.
* 2 x 16 backlit LCD, and power switch.
BACK PANEL
From left to right, there is the;
IEC power socket (power lead supplied).
MIDI In, Out, and Thru DIN type sockets.
Sync24 DIN socket.
Clock pulse 3.5mm minijack output.
Channel A and B CV and Gate 3.5mm minijack outputs.
The six auxiliary 3.5mm minijack outputs.
Above these is space for the optional expansion port, which (if fitted) is either a WASP/KADI
port or a DCB port .