Keri Systems SB-293 User Manual
Keri Systems Equipment
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Table of Contents
- Table of Figures
- Table of Tables
- 1.0 Features
- 2.0 Proximity - Principle of Operation
- 3.0 Specifications
- 4.0 Cable Requirements
- 5.0 PC/Doors Access Control Software Requirements
- 6.0 System Cautions
- 7.0 PXL-250/SB-293 System Installation
- 7.1 Advance Planning
- 7.2 Utility Requirements
- 7.3 Where Should Controllers be Installed?
- 7.4 Installing the Enclosure
- 7.5 The Enrollment Reader
- 7.6 Where Should Cables be Routed?
- 7.7 RS-485 Networking
- 7.8 PXL-250W Jumper Settings
- 7.9 SB-293 Jumper Settings
- 7.10 Installing the SB-293 Satellite Board onto the PXL-250 Controller
- 7.11 Wiring Connections to the Boards
- 8.0 Understanding Inputs and Outputs
- 9.0 Wiring Connections - PXL-250
- 9.1 Terminal Block Connections
- 9.2 TB-5/TB-6 - Reader Connection
- 9.3 TB-4 - Global Unlock or Auxiliary RTE Input Connection
- 9.4 TB-4 - Request to Exit Connection
- 9.5 TB-4 - Door Status Switch Connection
- 9.6 TB-3 - Alarm Relay Connection
- 9.7 TB-3 - Lock Relay Connection
- 9.8 TB-2 - Earth Ground/12 VDC Power Connection
- 9.9 TB-1 - RS-485 Controller Network Connection
- 9.10 RS-232 Controller/PC Connection
- 10.0 Wiring Connections - SB-293
- 10.1 Terminal Block Connections
- 10.2 Two-Door Configuration
- 10.2.1 TB-7 - Lock Relay Connection
- 10.2.2 TB-7 - Alarm Relay Connection
- 10.2.3 TB-10 - Door Held Open Alarm Relay Connection
- 10.2.4 TB10 - General Purpose Output Relay Connections
- 10.2.5 TB-8 - Door Status Switch Input Connection
- 10.2.6 TB-8 - Request to Exit Input Connection
- 10.2.7 TB-8 - Auxiliary Request to Exit Input Connection
- 10.2.8 TB-8/TB-9 - General Purpose Input Connections
- 10.3 Additional Inputs/Outputs Configuration
- 11.0 System Operation
- 12.0 Periodic Maintenance
- 13.0 Glossary
- 14.0 Index
- Appendices