Keri Systems Doors NetXtreme - Manual (Page 27)

Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 25
9.0 Create and Assign Property Sets
Figure 22: Select Template and Timezone
DoorsNXT utilizes property sets to allow for common attributes and/or functions to be created into a
template that may then be assigned to a number of individual buses, controllers, readers, operators, etc.
9.1 Doors/Gates Property Sets
A property set is a configuration of standard settings that determine the default behavior of the system.
DoorsNXT automatically receives information from the controller that will determine the template
assigned that most closely resembles the wiring of the system. There are four basic templates that may
be assigned. If the wiring of the system does not match one of the four basic templates, a new template
(with a number following) will be generated.
NOTE: Take care not to change this once the system has detected the configuration. The template will
determine what changes may be made to the system and changing the template will make some options
either available or unavailable incorrectly.
Standard 4 Door/Standard 2 Door = access control with readers attached to all Buses, without the
NXT 4x4 module attached.
Extended 4 Door/Extended 2 Door = access control with readers and the NXT 4x4 modules attached
to all Buses.
There may be times when it is necessary to change the template. Care should be taken when doing this.
NOTE: If the Autoconfig detects a change in the configuration, a new template will be created
automatically. However, this new template will not be assigned to the controller. If the new template is
to be used, it must be selected. Before changing the Property Template, it is recommended that the
configuration is Verified (see “Verify Controller Configuration” on page 21).
1. Change the controller Name to something that will make it easy to identify throughout the system
and in reports.
2. The basic template of the system may be changed using the drop-down menu available. Care
should be taken before assigning a different template. Only do this when you are sure it is
necessary.
3. Assign the geographical timezone for the physical location of the controller from the drop-down
menu. Only timezones that have been created elsewhere will be available for selection. See “Setup
Geographical Timezones” on page 16.