Keri Systems Doors NetXtreme - Manual (Page 36)

Figure 31: Assign Reader Type
Doors NetXtreme TM Reference Manual Keri Systems, Inc.
Page 34 01945-100 Rev. 4.0
9.2.4 Assign Reader Type
Click on Setup > System > Configure Controllers > Readers (tab).
1. Click on the to reveal all doors on the controller.
2. Verify the Readers tab has been selected to insure that all readers in the system are visible.
3. The following readers are supported:
• Keri NXT readers
• Keri MS readers (with use of a Reader Interface Module)
• Wiegand readers (with use of a Reader Interface Module)
• Non 26-bit Wiegand (with use of a Reader Interface Module)