Keri Systems Doors NetXtreme - Manual (Page 66)

Figure 64: Assign Dual Verification Property Set and Reader(s)
Doors NetXtreme TM Reference Manual Keri Systems, Inc.
Page 64 01945-100 Rev. 4.0
21.3 Assign Dual Verification Property Set and Reader(s)
Click on Setup > System.
1. Click on the “Configure Controllers” tab.
2. Click on the “+” to expand the controller information.
3. Select the “Doors/Gates” tab.
4. Select the bus that has the Dual Verification reader(s) attached.
NOTE: It is very important to do the following steps in the order specified. Failure to do so may cause
other columns that need to be set to not appear.
5. In the Reader column, use the drop-down menu to select “unassigned” for all readers on all busses.
6. In the Properties column, select the Dual Verification property set created previously. Return to the
Reader column and use the drop-down menu to select the appropriate reader on the controller and
bus to be used for Dual Verification.
7. The Secondary Reader column appears (if this column is not visible then Dual Verification has not
been enabled). This column is only to be used when 2 separate readers are to be used for Dual
Verification. One of the readers on another bus must be unassigned using the drop-down menu,
then assign that reader to the bus with Dual Verification. If a combo reader/keypad is in use, then
the Secondary Column must have the same reader assigned as is in the Reader column.
8. Click on the “Apply Changes” button.