Keri Systems Doors NetXtreme - Manual (Page 41)

Figure 36: Enroll Credentials - Learn Mode
Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 39
11.1.2 Enroll Credentials - Learn Mode
To enroll credentials through the “Learn Mode” method means that credentials are presented at the
reader rather than inputting the information by hand.
NOTE: Before beginning the “Learn Mode” process, perform an update on the controller (see “Update
the Network” on page 48).
NOTE: In order to make use of the “Learn Mode” method, DoorsNXT must be connected to the net. To
connect to the net, click on Manage > Network. The box next to “Net” will state whether DoorsNXT is
“connected” or “not connected” to the net. If it is not connected, click on the “Connecting to Net”
button.
1. Click on the “Create Credentials” button.
2. From the drop-down menu, select the reader to be used for presentation of credentials.
3. Click on the “Start Learn Mode” button. If Dual Verification has been enabled and secondary
credentials are to be enrolled, click on the “Start Secondary ID Learn Mode” button.
4. Use the drop-down menu to select the type of Format for the credential.
5. If Dual Verification has been enabled, the “Type” column will appear. Use the drop-down menu to
select whether the credential is to be a primary or secondary credential.
6. Click on the “ + ” to expand the visible information.
7. Present the credentials to the selected reader. As each credential is presented to the reader, it is
listed.
8. Once all credentials have been presented, click on the “Stop Learn Mode” button.
9. Click on the “Apply Changes” button.
NOTE: When using “Learn Mode” to enroll both primary and secondary credentials, the process must
be done separately for each. Go through all the steps to enroll the primary credentials. Click on the
“Apply Changes” button, then go through all the steps to enroll the secondary credentials.