LABEC AA-12S - Manual (Page 11)

SEA Series Steam Sterilizers
Operation manual 7
5. Operation of 8L/12L
Please connect the power cord before you start the operation.
Press the mains power switch at right lower corner of the front panel. The power switch light
turns on indicating that electric power is connected. All keyboards goes on, automatically
examine. It will indicate error code and alarm when examine failed. It will indicate Ld
when pass examination.
5.1 Fill water
If the water level is lower than the lowest water level. When the power switch is on, select the
sterilize program, the water indication light may glinting while alarm Beeps. At this time,
you need to refill the reservoir. Please open the water tank and pour water into it by container.
Please pay attention to the water level during filling water, you should stop filling when the
surface is close to the red water level mark.
1.Distilled water must be good for prolonging life of the machine.
2.Don't tilt the autoclave where there is water in the reservoir.
3.The used water tank should be emptied frequently. You should evacuate the used water
reservoir usually when water reservoir is empty.
Fig 5-1