LABEC Shinva-45N - Manual (Page 10)

8
3 The screen will display program parameters and picture as follows after the door is
opened
3.2.3 Vacuum Test
1 Press“▲” key or “▼” key until screen display 6# vacuum test program shows as
following，close the door and press “on/off” key and the vacuum test program will
start.
2 The buzzer alarming will remind user that the vacuum test program is finished, and
screen will display the following:
3 Leakage rate must be lower than 0.13KPa/min。
3.2.4 B&D Test
1 Press“▲”key or“▼” key until screen display 5#B&D test program picture shows as
following:
1#i ns t r ument door : open
St er i l i zat i on t emper at ur e ：134. 0℃
St er i l i zat i on t i me： 4. 0 mi nut es
Dr ynes s t i me： 2. 0 mi nut es
6#vacuum door : open
Test leakage rate
6#vacuum t es t 20：00
Leakage r at e：
0. ***kPa/ Mi n
Pl eas e open t he door
5#BDt es t door : open
St er i l i zat i on t emper at ur e ：134. 0℃
St er i l i zat i on t i me： 3. 5 mi nut es
Dr ynes s t i me： 2. 0 mi nut es