Analyze sample, Basic mode, Select test mode – LABEC V-18 User Manual

Page 11: Begin to test

Advertising
background image

16/18 Manual

8

Analyze Sample

We provide three test methods in

UV

16/18 series, they are basic mode test, quantitative

and kinetics.

1. Basic Mode

Push the blank cuvette into the light path. In main menu (the last one of Fig. 3), move the

cursor on “Basic mode”, then press

【ENTER】

to go into basic mode test. After

automatically blanking, it will display as the left one of Fig. 4 and wait for the operator.

【RETURN】

to exit.

☺ Select Test Mode

There are three test modes (T%, Abs, Conc. / factor) for you to select by pressing

【SET】

to make choice.

【SET】


【RETURN

RETURN

RETURN

RETURN】


Fig.7

Use

【 】

and

【 】

to move the cursor on

●

●

●

●

Abs. ,

then press

【ENTER】,

If the icon

“

√

√

√

√”

appears at the end of

●

●

●

●

Abs. ,

you have selected successfully. Press

【RETURN

RETURN

RETURN

RETURN】

to exit to the left of Fig.4, blank at the same time. (Fig. 7)

The operation is the same as

Abs

test mode to

select

T%

mode and

Energy

mode.

☺ Begin to Test

Push the sample into light path, press

【 START

START

START

START 】

to go into basic mode test

interface.(Fig. 8)

START

RETURN

Fig. 8

Press

【START

START

START

START】

again, the test result will display on the screen. The operation is the

same if you change your samples.

Note:

√

√

√

√Basic Mode:

●

●

●

●Abs.

√

√

√

√

○

○

○

○T%
○

○

○

○Energy

Basic Mode:

:

:

:

0.000

Abs

546.0 nm

Basic Mode:

:

:

:

0.000

Abs

500.0 nm

500.0nm 0.000Abs

No. WL Abs

1

500.0 0 .000

Advertising
This manual is related to the following products: