LABEC V-18 - Manual (Page 16)

16/18 Manual
13
to go back to pre-testing interface.
Note: If you want to delete a equation, move the cursor on it, just
press 【 【 【 【
CLEAR
】 】 】 】.
☺ Test and Print
When you have selected the equation, press
【
START/STOP
】
to go into testing
interface in pre-testing interface.(Fig. 19)
START
RETURN
Fig. 19
After blanking, pull the unknown sample cuvette in the light path, then press
【
ENTER
】 , the testing result will be displayed on the screen. Operation is the
same if you want to test other samples.
Press
【PRINT】 to print testing results. （ Fig. 20 ）
Fig. 20
2-2. Coefficient Method
If you have known the standard curve equation, you can use this method to test.
Move the cursor on the Coefficient by pressing 【 】 and 【 】 , after 【
ENTER
】
being expressed, it goes into the formula selecting interface. （ （ （ （
Fig.21
） ） ） ）
ENTER
RETURN
Fig. 21
Choose the formula you need by pressing “1” or “2” of the numeric keypad,
you’ll enter the coefficient method pre-testing interface.(Fig.22)
You can also select by pressing 【 】 and 【 】 followed by 【
ENTER
】 .
Standard Curve： ： ： ：
0.000 Abs
0.000 ml/l
546.0 nm
546.0nm -0.000Abs
No. WL Abs Conc
1 546.0 0.001 1.0 g/l
Coefficient
1. A=KC+B
2. C=KA+B
√ √ √ √Quantitative
○ ○ ○ ○Standard Curve
● ● ● ●Coefficient
Standard Curve
NO. Abs. T% Conc.
1 0.000 100.0% 0.0g/l
2 0.000 100.0% 0.0g/l