LABEC V-18 - Manual (Page 28)

16/18 Manual
25
When you have replaced a new lamp, you’ll have to go into the lamp life
setting interface, move the cursor on the “Reset W Life” or “Reset D2 Life” by
pressing
【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 followed by 【
ENTER
】 to reset them into zero.
Load Default
Move the cursor on “ Load Default” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 in utility
setting interface, then press 【
ENTER
】 (Fig. 52)
ENTER
RETURN
Fig. 52
If you want to default the parameters, choose “Yes” in the right interface of
Fig. 52, or you should choose “No”.
Press 【
RETURN
】 to exit without any choice.
Lamp Change
Move the cursor on “ Lamp Change” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 in utility
setting interface, then press 【
ENTER
】 (Fig. 53)
ENTER
RETURN
Fig. 53
I nput the new wavelength you want by pressing the numeric keypad
followed by 【ENTER】 .
Lamp change wavelength means the point at which W lamp and D2 lamp
exchange. The range of it is 300-400, other value is invalid.
Version of Instrument
Move the cursor on “ Version” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 in utility setting
interface, then press 【
ENTER
】 , you will find the detailed messages of the
instrument. (Fig. 54)
Fig. 54
Lamp Change
WL=340.0nm
Please Input New：
： ： ：
WL=
Style： ： ： ： SPECTRO-UV16
Software： ： ： ：1.0.2
Hardware： ： ： ：1.1
Shanghai
Load Default？ ？ ？ ？
● ● ● ●Yes
○ ○ ○ ○No
√ √ √ √Utility
○ ○ ○ ○Lamp Life
● ● ● ●Load Default
○ ○ ○ ○Lamp Change
√ √ √ √Utility
○ ○ ○ ○Lamp Life
○ ○ ○ ○Load Default
● ● ● ●Lamp Change