Pss - use short sequence, Syntax, Defined values – Longshine LCS-8156C1 User Manual
Page 116: Result codes, Reporting selected values, Reporting supported range of parameter values
AT Commands for CX930xx Modem Reference Manual
3-92
Conexant
102752B
+PSS - Use Short Sequence
This command causes a calling modem to force either a V.92 short or full startup
sequence as defined by the +PQC command on the next and subsequent connections.
Syntax
+PSS=<value>
Defined Values
<value>
Decimal number corresponding to the selected sequence.
0
The modems decide whether or not to use the
short startup procedures. The short startup
procedures can only be used if enabled by the
+PQC command. (Default.)
1 Reserved.
2
Forces the use of the full startup procedures on
the next and subsequent connections independent
of the setting of the +PQC command.
Result Codes
OK
0 - 2 in V.92 Mode (+MS=V.92)
ERROR Otherwise
Reporting Selected Values
Command: +PSS?
Response: <value>
Example:
0
For the default <value>.
Reporting Supported Range of Parameter Values
Command: +PSS=?
Response: (<value>
range)
Example: (0-2)