Vit - voice inactivity timer (dte/modem), Syntax, Defined values – Longshine LCS-8156C1 User Manual
Page 175: Reporting current or selected values, Reporting supported range of parameter values, Result codes, Vls - analog source/destination selection
AT Commands for CX930xx Modem Reference Manual
102752B
Conexant
5-11
+VIT - Voice Inactivity Timer (DTE/Modem)
This command sets the modem’s initial value for the DTE/modem inactivity timer.
Syntax
+VIT=<timer>
Defined Values
<timer>
Decimal number corresponding to the time in units of 1.0
second. A value of 0 disables the timer.
Reporting Current or Selected Values
Command: +VIT?
Response: <timer>
Example:
0
For the default setting.
Reporting Supported Range of Parameter Values
Command: +VIT=?
Response: <timer>
range
Example: 0-255
Result Codes
OK
<timer> = 0-255.
ERROR
Otherwise, or if not in Voice Mode.
+VLS - Analog Source/Destination Selection
This command causes the modem to select one or more source/destinations of the analog
data.
Syntax
+VLS=<label>
Defined Values
<label>
Decimal number corresponding to the selected analog
source/destination hardware configuration (see Table 5-5).
Command: +VLS?
Response: <label>
Example:
0
For the default setting.