Longshine LCS-8156C1 - Manual (Page 153)

AT Commands for CX930xx Modem Reference Manual
102752B Conexant 4-11
+FTH - Transmit Data with HDLC Framing
This command causes the modem to transmit data using HDLC protocol and the
modulation defined below.
Syntax
+FTH=<mod>
Defined Values
<mod> Decimal number corresponding to the selected modulation
mode and data rates shown in Table 4-2.
Result Codes
CONNECT Reported for either of two conditions:
1. At the beginning of transmission of the training pattern
for the selected modulation.
2. If the Final Frame bit is 0.
OK Reported for either of two conditions:
1. If the Final Frame Bit is 1.
2. if the DTE sends only <DLE><ETX> (a null frame) while
transmitting flags.
ERROR Reported if five seconds elapse from the time when the
modem reported the CONNECT result code without any
additional data transmitted from the DTE; the modem then
turns off carrier and returns to the command mode.
Reporting Current or Selected Values
Command: +FTH?
Response: +FTH: <mod>
Example: +FTH: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FTH?
Response: +FTH?
Example: +FTH: 98 For V.17 9600 bps.