New England Arbors VA74338 - Manual (Page 2)

2
S T E P O N E
Lay out one of the posts (part 1). Measure 8” from one end of the post and
put a mark. Center the rail mount bracket (part 8) on the post, with the
open end at the 8” mark. Using two screws, fasten the bracket to the post
as illustrated. Repeat this for the second post. Note: All screws are self-
tapping and require no pre-drilling.
Take one of the posts and measure 29” from the same end of the post as
in step 1. Put a mark on the post at this distance.
Slip one of the base moldings (part 7) onto the opposite end of the post
as illustrated. Slide it up the post until the top edge of the molding is at the
29” mark.
Center another rail mount bracket on the base molding, keeping the open
end of it tight against the raised lip of the base molding trim. Fasten the
bracket in place using two screws. Repeat steps A through C for the other
post. Note: The distance between the two brackets should measure approx-
imately 18 3/4” when finished.
Cottage Picket Wings Installation
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
A
A
B
B
C
8”
29"
C