New England Arbors VA74338 User Manual
Page 3
3
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
S T E P T W O
A
Insert the bottom rail (part 3) into the bracket on the base molding.
Make sure the holes in the rail are facing towards the second bracket
on the post. Using one screw, secure the rail in place through the side
wall of the bracket as illustrated. Repeat this for the opposite side wall.
Insert the top rail (part 2) into the second bracket, making sure the
larger sized holes in the rail are facing towards the bottom rail. Secure
the rail as described in the previous step. Note: The holes in the rail are
approx. 1/8” larger on one side to allow for proper alignment of the
pickets when mounting. Repeat steps A and B for the remaining post
and rails.
Break open one bundle of pickets (part 4). Start with the 41” picket at
the furthest end of the rails, and insert each one in decending order,
ending with two 29 1/4” pickets at the post. Make sure the tabs on the
end of the pickets “snap” into the bottom rail. Open the second bundle
of pickets and repeat for the opposite wing panel.
A
B
C
Bottom Rail is
only routed on
the one side
Top rail is routed
on both sides:
The larger
opening faces
the bottom rail.
B
C