New England Arbors VA74338 User Manual
Page 4
4
S T E P T H R E E
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
A
A
B
C
B
Determine which side of your arbor the wings will be attached to.
Fasten a rail mount bracket to the outside of the arbor base molding in
the same manner as described in step one (c). Note: If your arbor does
not have a base mold, install bracket directly on arbor (B). You will need
to use 1/2” filler (A) as bottom rail is shorter to allow for base mold.
Using two screws, fasten a second bracket to the outside of the arbor
post as illustrated. The distance between the brackets on the arbor
post must equal the distance measured between the brackets on the
wing post. Repeat steps A and B for the arbor side panel.
Using the distances shown, mark out each hole location on both sides
of the arbor. Dig out two 16” deep holes.
1/2” Filler
(used when no base trim is
present on the arbor post).
42"
49"
15.5"
C
Ground Level