New England Arbors VA42044 - Manual (Page 10)

134 in.
340.4 cm.
146 7/8 in.
373 cm.
Vinyl Beam Assembly
1
www.edenarbors.com
Insert one 2x6x12 pressure treated wood into a beam followed
by the joiner and another beam section.
Critical Note:
Note the location of the pre-drilled holes on beams. As pictured
aside, the further distanced holes need to mate together inside
the beam joiner. this is critical to ensure equal spacing of your
rafters.
Install the rafter brackets to the main beams using 5/8”
screws. Only attach four brackets to the beam as shown.
Follow the pre-drilled holes to identify locations.
Screw the joiner to vinyl beams and wood insert using 1 1/2”
screws.
1
2
3
S T E P F O U R
10 12 x 12 Flat Top Pergola
At this stage, the columns should be properly
installed as per the following illustration,
with the columns 134” in. (340.4 cm) apart.
Critical : Note the opening direction
of the holes on the top of the posts.
Four holes
facing up Pre-drilled holes
on the top
3
2
4.75”
11.5” 11.5”
4.75”
Distance to first hole
*)Only attach four brackets to the
beam. ( two on each side of the
joiner)