Novak ESC Profile Software - Manual (Page 18)

NOVAK ELECTRONICS • PROFILE SOFTWARE 18
DOWNLOADING PARAMETERS TO CYCLONE
The following steps will allow you to download the Profile that is
currently displayed in the Edit Current Parameters mode of the
software to the Cyclone. The downloaded Profile will always be
the active Profile in the Cyclone even if this is the first time Profile
4 has been activated. You will now have the original three Profiles
that came with the Cyclone, plus the custom Profile (Profile 4) to
choose from through the One-Touch button.
Refer to your Cyclone Owner’s Manual for instructions on selecting Profiles.
1. With DataLink connected as previously instructed, turn on the
DataLink’s power switch. Red power LED will blink on and off.
2. Turn on your transmitter, then turn on your speed control.
Note: Use a DSC cord to disable the transmitter’s RF section to avoid
radio interference. If you do not have your transmitter or a DSC cord,
disconnect servo from receiver and lift vehicle’s wheels into the air
until D•LINK is connected.
Note: Motor will be disabled as soon as D•LINK harness is connected.
3. Connect the DataLink’s D•LINK harness to your Cyclone’s
DataLink socket located on the top of the speed control. The
D•LINK connector will only clear the transistors of the speed
control if the “D•LINK” lettering is right side up. If you have
external heat sinks installed, be sure that they do not extend
beyond the front edge of the transistors, as they may have to
be repositioned to gain access to the connector.
At this time the Cyclone’s LED should be illuminated solid red.
4. From the main menu, use the up {
↑
} or down {
↓
} arrow keys
to highlight “Download Parameters To Cyclone”, then press
{Enter} or {Return} to select.
5. Press {Enter} or {Return} to download the parameters to the
Cyclone.
6. After the downloading process is complete, the software will
return you to the main menu.