Philips MX920AHT-37 - Manual (Page 8)

G etting S tarted
ANTENNA Hookup Instructions
Connect the Antennas to the Home Theater Receiver:
Connect the two ends of the FM Antenna to the Home
Theatre Receiver’s “300 ohm FM’’ terminals.
Connect the two ends of the AM Antenna to the Home
Theatre’s “AM” terminals.
NOTES; The FM Antenna should be positioned so that it is
completely spread out. The AM Antenna can be mounted by
pressing the Antenna into the AM Antenna Clip on the back
of the Receiver.
FM ANTENNA
о----
VCR Hookup Instructions
If the VCR is already properly connected to the TV, skip to step 5:
Connect the Cable (or Antenna) to the VCR’s “IN FROM ANT” input.
t With an additional R.F. Cable (usually supplied with VCR), connect
the VCR’s “OUT TO TV” to the Television’s “ANT/CABLE” input.
Connect the Hi-Fi VCR to the Home Theatre Receiver:
With the red and white tipped phono plug connectors (supplied), connect
the VCR’s left and right “AUDIO OUT” jacks to the Home Theatre
Receiver’s left and right “VCR/TAPE IN” audio jacks.
If your TV has an AUX(illary) VIDEO INPUT, you can connect the
VCR’s video signal to your TV as follows:
^ Using an additional phono plug (not supplied), connect the VCR’s
“VIDEO OUT” jack to the TV’s AUX(illary) “VIDEO IN” jack.
NOTES; For TV hookup and operation details, refer to your TV’s owner’s manual.
The VCR can be placed on top of the Home Theatre Receiver.
1Ж! w
s
Ы
s
NOTE; Push and hold Speaker terminal
tab down to insert wire. Release tab to
lock wire in terminal. Make sure the
insulation is completely removed from
the ends of the Antenna and Speaker
wires at all connection points.