Cleaning the parksense® system, Parksense® system usage precautions – Ram Trucks 2014 3500 - Owner Manual User Manual
Page 201
REVERSE and the system has detected a faulted condi-
tion, the EVIC will display the
ЉPARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS
Љ or the ЉPARKSENSE UN-
AVAILABLE SERVICE REQUIRED
Љ message for as long
as the vehicle is in REVERSE. Under this condition,
ParkSense® will not operate.
If
ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ
appears in the Electronic Vehicle Information Center
(EVIC) make sure the outer surface and the underside of
the rear fascia/bumper is clean and clear of snow, ice,
mud, dirt or other obstruction, and then cycle the igni-
tion. If the message continues to appear, see an autho-
rized dealer.
If
ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
appears in the EVIC, see your authorized dealer.
Cleaning The ParkSense® System
Clean the ParkSense® sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
ParkSense® System Usage Precautions
NOTE:
• Ensure that the rear bumper is free of snow, ice, mud,
dirt and debris to keep the ParkSense® system oper-
ating properly.
• Jackhammers, large trucks, and other vibrations could
affect the performance of ParkSense® .
• When you turn ParkSense® off, the instrument cluster
will display
ЉPARKSENSE OFFЉ. Furthermore, once
you turn ParkSense® off, it remains off until you turn
it on again, even if you cycle the ignition key.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
199