Ram Trucks 2014 3500 - Owner Manual - Manual (Page 208)

When the shift lever is moved to REVERSE and the Front
or Rear system is disabled, the EVIC will display the
ЉFRONT PARKSENSE OFFЉ or ЉREAR PARKSENSE OFFЉ
message for five seconds, followed by a car graphic with
ЉOFFЉ in the corresponding side. This car graphic will be
displayed for as long as the vehicle is in REVERSE.
NOTE: Arc alerts from the enabled ParkSense® system,
will interrupt the five second messages, and the EVIC
will display the car graphic with the corresponding arcs
and
ЉOFFЉ message.
The Front or Rear ParkSense® switch LED will be ON
when Front or Rear ParkSense® is disabled or requires
service. The Front or Rear ParkSense® switch LED will
be OFF when the Front or Rear system is enabled. If the
Front or Rear ParkSense® switch is pressed, and the
system requires service, the Front or Rear ParkSense®
switch LED will blink momentarily, and then the LED
will be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the
ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORS
Љ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORS Љ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED Љ message for five seconds.
When the shift lever is moved to Reverse and the system
has detected a faulted condition, the EVIC will display a
ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ,
ЉPARKSENSE UNAVAILABLE WIPE FRONT SENSORSЉ
or
ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with
ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
206 UNDERSTANDING THE FEATURES OF YOUR VEHICLE