Cargo camera — if equipped, Turning cargo camera on or off — with, Uconnect® 8.4a/8.4an – Ram Trucks 2014 3500 - Owner Manual User Manual

Page 252

Advertising
background image

There are stampings in the sheet metal on the inner side
bulkheads of the box in front of and behind both wheel
housings. Place wooden boards across the box from side
to side to create separate load compartments in the
pickup box.

There are four tie-down cleats bolted to the lower sides of
the pickup box that can sustain loads up to 1000 lbs
(450 kg) total.

Cargo Camera — If Equipped

Your vehicle may be equipped with the Cargo Camera
that allows you to see a image of the inside of the pickup
box. The image will be displayed in the Uconnect®
screen.

A display timer is initiated when the cargo camera image
is displayed. The image will continue to be displayed
until the display timer exceeds 10 seconds and the vehicle
speed is above 8 mph (13 km/h) or the image is deacti-
vated by touching the Uconnect® display.

NOTE:

If the vehicle speed remains below 8 mph

(13 km/h), the cargo camera image will be displayed
continuously

until

deactivated

by

touching

the

Uconnect® display.

The Cargo Camera is located in the bottom center area of
the center high-mounted stoplamp (CHMSL).

NOTE:

If snow, ice, mud, or any foreign substance builds

up on the camera lens, clean the lens, rinse with water,
and dry with a soft cloth. Do not cover the lens.

Turning Cargo Camera On Or Off — With
Uconnect® 8.4A/8.4AN

1. Press the “Controls” soft-key located on the bottom of

the Uconnect® display.

2. Press the “Cargo Camera” soft-key to turn the Cargo

Camera system ON.

250

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising
This manual is related to the following products: