Ram Trucks 2014 3500 - Owner Manual User Manual

Page 463

Advertising
background image

• If the vehicle is in OFFROAD1 or OFFROAD2 setting,

be aware of your surroundings, you may not have the
clearance required for certain areas and vehicle dam-
age may occur.

Aero Mode (Lowers the vehicle approximately .6 in

[15 mm])

– This position provides improved aerody-

namics by lowering the vehicle. The vehicle will
automatically enter Aero Mode when the vehicle
speed remains between 62 mph (100 km/h) and
66 mph (106 km/h) for greater than 20 seconds or if the
vehicle speed exceeds 66 mph (106 km/h). The vehicle
will return to NRH from Aero Mode if the vehicle
speed remains between 30 mph (48 km/h) and 35 mph
(56 km/h) for greater than 20 seconds or if the vehicle
speed falls below 30 mph (48 km/h).

NOTE:

Automatic Aero Mode may be disabled through

vehicle settings in the Electronic Vehicle Information
Center (EVIC) when equipped with Uconnect 3.0, or your

Uconnect® Radio when equipped with UConnect® 5.0,
8.4A, or 8.4AN. Refer to

ЉElectronic Vehicle Information

Center (EVIC)

Љ in ЉUnderstanding Your Instrument

Panel

Љ or “Uconnect® Settings” in “Understanding Your

Instrument Panel” for further information.

Entry/Exit Mode (Lowers the vehicle approximately 2

in [51 mm])

– This position lowers the vehicle for

easier passenger entry and exit as well as lowering the
rear of the vehicle for easier loading and unloading of
cargo. To enter Entry/Exit Mode, press the “Down”
button once from the NRH while the vehicle speed is
below 33 mph (53 km/h). Once the vehicle speed goes
below 15 mph (24 km/h) the vehicle height will begin
to lower. If the vehicle speed remains between 15 mph
(24 km/h) and 25 mph (40 km/h) for greater than 60
seconds, or the vehicle speed exceeds 25 mph
(40 km/h) the Entry/Exit change will be cancelled. To
return to Normal Height Mode, press the “Up” button
once while in Entry/Exit or drive the vehicle over

5

STARTING AND OPERATING

461

Advertising
This manual is related to the following products: