Tensioning the wire rope, Low voltage interrupt – Ram Trucks 2014 3500 - Owner Manual User Manual

Page 501

Advertising
background image

Tensioning The Wire Rope

The winch rope must be properly tensioned before use.
Follow the instructions below to tension the rope:

1. Un-spool the wire rope leaving five wraps of rope on

the winch drum.

2. Attach the hook to a suitable anchor point.

CAUTION!

Be certain the anchor will withstand the load re-
quired to tension the wire rope.

3. Apply at least 500 lbs (227 kg) of tension to the rope

while winding the rope. Always use care to ensure the
rope does not pile up on one side of the drum and is
neatly wound onto the drum.

CAUTION!

Wire rope must spool on the winch drum in the
direction indicated on the drum rotation decal on the
winch.

Low Voltage Interrupt

Your winch is equipped with a device that will interrupt
winch function if the vehicle charging system voltage
drops to a low level. The winch will not power-in or out
for 30 seconds if this device is tripped. If the interrupt is
tripped, the vehicle should be operated at high idle for a
few minutes to allow the vehicle charging system to
recover before continuing to winch.

5

STARTING AND OPERATING

499

Advertising
This manual is related to the following products: