Maintaining your vehicle, Opening the hood, Adding fuel – Ram Trucks 2014 Cargo Van Commercial - User Guide User Manual

Page 114: Fuel filler cap (gas cap)

Advertising
background image

OPENING THE HOOD

1. Pull the hood release lever located on

the instrument panel, below the steer-
ing column.

2. Raise the hood and locate the safety

catch lever, in the middle of the hood
opening.

3. Move the safety latch while lifting the

hood at the same time.

4. Insert the support rod into the slot on

the hood.

5. To close the hood, remove the support

rod and place it in the retaining clip,
then lower the hood slowly.

WARNING!

Be sure the hood is fully latched before driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in motion and block your vision. Failure
to follow this warning could result in serious injury or death.

ADDING FUEL

Fuel Filler Cap (Gas Cap)

• The gas cap is located behind the fuel

filler door on the left side of the ve-
hicle. If the gas cap is lost or damaged,
be sure the replacement cap is for use
with this vehicle.

• When the fuel nozzle “clicks” or shuts

off, the fuel tank is full.

• Tighten the gas cap until you hear a

“clicking” sound. This is an indication
that the gas cap is properly tightened.
If not properly tightened, the MIL
(Malfunction

Indicator

Light)

may

come on.

NOTE:
The driver’s side sliding door cannot be
opened while the fuel door is open.

MAINTAINING YOUR VEHICLE

112

Advertising