Before you begin programming homelink, Programming a rolling code, Electronics – Ram Trucks 2014 Cargo Van Commercial - User Guide User Manual

Page 85

Advertising
background image

Before You Begin Programming HomeLink®

Ensure that your vehicle is parked outside of the garage before you begin program-
ming.

For efficient programming and accurate transmission of the radio-frequency signal,
it is recommended that a new battery be placed in the hand-held transmitter of the
device that is being programmed to the HomeLink

®

system.

Erase all channels before you begin programming. To erase the channels, place the
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink

®

buttons (I and III) for up to 20 seconds or until the red indicator flashes.

NOTE:
Erasing all channels should only be performed when programming HomeLink

®

for

the first time. Do not erase channels when programming additional buttons.

If

you

have

any

problems,

or

require

assistance,

please

call

toll-free

1-800-355-3515 or, on the Internet at www.HomeLink.com for information or
assistance.

Programming A Rolling Code

NOTE:
For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.

1. Place the ignition switch into the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink

®

button you wish to program while keeping the HomeLink

®

indicator light in view.

3. Simultaneously press and hold both the HomeLink

®

button you want to program

and the hand-held transmitter button.

4. Continue to hold both buttons and observe the indicator light. The HomeLink

®

indicator will flash slowly and then rapidly after HomeLink

®

has received the

frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.

5. At the garage door opener motor (in the garage), locate the “LEARN” or

“TRAINING” button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly press and release the
“LEARN” or “TRAINING” button.

NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pressed.

ELECTRONICS

83

Advertising