Anti-lock brake (abs) light, Electronic throttle control (etc) indicator light, Air bag warning light – Ram Trucks 2014 Cargo Van Commercial - User Guide User Manual

Page 98: Fuel cap/loose gas cap message, Change oil” message, What to do in emergencies

Advertising
background image

- Anti-Lock Brake (ABS) Light

This light monitors the Anti-Lock Brake System (ABS).

If the light is not on during starting, stays on, or turns on while driving, we
recommend you contact the nearest authorized dealer and have the vehicle serviced
immediately.

- Electronic Throttle Control (ETC) Indicator Light

This light informs you of a problem with the system.

If a problem is detected, the light will come on while the engine is running. Cycle the
ignition when the vehicle has completely stopped and the shift lever is placed in the
PARK position; the light should turn off.

If the light remains lit with the engine running, your vehicle will usually be drivable;
however, see an authorized dealer immediately. If the light is flashing when the
engine is running, immediate service is required and you may experience reduced
performance, an elevated/rough idle or engine stall and your vehicle may require
towing.

- Air Bag Warning Light

If the light is not on during starting, stays on, or turns on while driving, have the
vehicle serviced by an authorized dealer immediately.

Fuel Cap/Loose Gas Cap Message

If a “gas cap” message (shown as gASCAP) appears, tighten the gas cap until a
“clicking” sound is heard.

If the message continues to appear for more than three days after tightening the gas
cap, see your authorized service center.

“CHANGE OIL” MESSAGE

• If a “Change Oil” message appears and a single chime sounds, it is time for your

next required oil change.

Resetting The Light After Servicing

Vehicles Equipped With Keyless Enter-N-Go™

• Without pressing the brake pedal, push the ENGINE START/STOP button and

cycle the ignition to the ON/RUN position (do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Without pressing the brake pedal, push the ENGINE START/STOP button once to

return the ignition to the OFF/LOCK position.

WHAT TO DO IN EMERGENCIES

96

Advertising