Carrier Access Access Bank II SNMP - Manual (Page 160)

Command Line Interface (CLI)
9/24/01 14-15
carrier on|off ..Loss of carrier detected
csuloop on|off ..CSU loop code received
unframed on|off ..Unframed, all 1’s received
sync on|off ..Loss of sync
yellow on|off ..Yellow alarm received
bpv on|off ..BPVs exceed 1544 in 15 min period
ses on|off ..SES exceed 10 in 15 min period
unavail on|off ..Unavailable seconds in 15 min period
fdlline on|off ..FDL line loop request received
fdlpay on|off ..FDL payload loop request received
loop .................Display/Set Loopback State
none ...............Disable any Current Loopback
a d t ..............General Loopback Usage:
a - Access Port:
vn - for V.35 port #n
dn - for DS1 port #n
d - Direction of Loopback:
equipment - towards customer equip
network - towards network
t - Type of Loopback:
line - line loopback
payload - payload loopback
D1 toward Net ......> loop d1 network line
..................> loop d1 network payload
V1 toward Router ..> loop v1 equipment line
..................> loop v1 equipment payload
mac .................Display 6 byte MAC addr in Hex
make ................Display/Make Connection Assignments
s:c|vm|r1 s:c [n] [i]Connection Definitions:
s - span name: d1,d2...,f1,f2,...
c - channel number: 1...
n - number of channels to connect,
default 1 for a single channel
i - channel increment, default 1,
2 means every other channel, etc.
vm - V.35 span, m = 1...
r1 - User Data RS-232 span
s:c - half cnct, T1 or FX channel
D1 to FX1 ..........> make d1:1 f1:1 12
V.35 to D1 .........> make v1 d1:23 2
name .................Display/Set Name Configuration
circuitid s “id” ...Display/Set Circuit ID for span s:
d1, d2, f1, f2, v1, etc
session “prompt” ...Display/Set Session Prompt Name
system “name” ......Display/Set System Name
password .............Change password
ping ipaddr [n] [d] ..Send IP Ping to ipaddr up to n times
with d ms delay between pings