Installation – Slant/Fin SC-3 User Manual

Page 2

Advertising
background image

3

SC-3 Controller

Remove the safety dividers
from the wiring chamber by
pulling them straight out of their
grooves.

The control can be mounted on
a standard DIN rail. First
remove the control from its
base and then, using the hooks
and spring clip on the back of
the control, mount it onto the
DIN rail. This will be a popular
option for those who prefer to
mount the control inside a larg-
er electrical panel.

Press the control release clip
on the base inside the wiring
chamber and slide the control
upwards.

The control lifts up and away from
the base.

The wiring can enter the bottom or
the back of the enclosure. Knock-
outs provided in the base allow the
wiring to be run in conduit up to the
enclosure. The base also has holes
that line up with the mounting holes
of most common electrical boxes.

The base is ready for mounting.

CONTROL PANEL MOUNTING

The control panel is to be mounted in an indoor area where the ambient temperature range will be 30 to 120˚F (0 to 50˚C) and less that

95% RH. Power Supply is to be 115 V (ac) +/- 10% 50/60 Hz 600 VA.

The installer must ensure that this control and its wiring are isolated and/or shielded from strong sources of electromagnetic noise.
Conversely, this Class B digital apparatus complies with Part 15 of the FCC Rules and meets all requirements of the Canadian Interference-
Causing Equipment Regulations. However, if this control does cause harmful interference to radio or television reception, which is deter-
mined by turning the control on and off, the user is encouraged to try and correct the interference by re-orienting or relocating the receiving
antenna, relocating the receiver with respect to the control, and/or connecting the control to a different circuit from that to which the receiver
is connected.

WARNING: The nonmetallic enclosure does not provide grounding between conduit connections. Use grounding type bushings and jumper
wires as needed.

INSTALLATION

CAUTION

Improper installation and operation of this control could result in damage to the equipment and possibly even personal injury. It is your
responsibility to ensure that this control is safely installed according to all applicable codes and standards. This electronic control is not
intended for uses as a primary limit control. Other controls that are intended and certified as safety limit must be placed into the control
circuit. Do not open the control. Refer to qualified personnel for servicing. Opening voids warranty and could result in damage to the
equipment and possibly even personal injury.

Press down at the fingertip
grips on top of the front cover
and pull out and down.

Lift the front cover up and away
from the control.

Loosen the screws at the front
of the wiring cover.

The wiring cover pulls straight
out from the wiring chamber.

Advertising