Slant/Fin SC-3 - Manual (Page 21)

SC-3 Controller 22
VIEW THE PERFORMANCE
FUNCTION DESCRIPTION STEPS
OUTDOOR Current outdoor air temperature
as measured by the outdoor
sensor. Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until OUT appears. Read the numeric display.
BOILER SUPPLY
Current boiler supply water
temperature as measured by the
boiler supply sensor. Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until BOIL SUP appears. Read the numeric display.
BOILER TARGET
Boiler target temperature is the
temperature the control is trying
to maintain at the boiler supply
sensor. Move the Adv/ Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until BOIL TARG appears. Read the numeric display.
Move the Adv/ Installer DIP switch back to the Installer position.
BOILER 1 HOUR
The total running time of
module 1 since this item was
last cleared. Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 1 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
BOILER 2 HOURS
The total running time of
module 2 since this item was
last cleared. Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 2 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
BOILER 3 HOURS
The total running time of
module 3 since this item was
last cleared. Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 3 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
Follow the above procedure for all remaining boiler stages