Slant/Fin TRDV Series Venting - Manual (Page 4)

4 TRDV SERIES
FIGURE 4: Joint assembly
INSTALLING THE JOINT ASSEMBLY
1. Loosen the gear clamps attached to the adapter sleeve and
slide the adapter sleeve over the vent pipe, Figure 4 and
Figure 5.
2. Pull the corrugated inner tube out of the vent pipe for easy
access and insert the adapter.
3. Apply sealant around the corrugated end of the adapter.
4. Align the flat seams at the end of both corrugated tubes and
insert the adapter into the vent tube. Screw the adapter into
the vent pipe with a counter-clockwise motion. The adapter
should be fully inserted into the inner vent tube until it’s tight.
The seams of both tubes must be aligned for ease of insertion.
If the adapter does not completely screw into the vent pipe,
unscrew it and try again as per Step #4.
5. Seal around the edge of vent pipe inner tube.
6. Slide the adapter sleeve back onto adapter and tighten the
gear clamps to complete the connection.
7. If the vent requires cutting to length, a fine tooth hacksaw can
be used. Remove any burrs and flare out the end of the inner
vent tube for easy installation of the adapter.
FIGURE 5: Joint assembly
FLEX- L