Vexilar LC-10 - Manual (Page 5)

ASSEMBLING THE TRANSDUCER
Locate the transducer and bracket assembly. This
includes:
1 - Transducer
1 - Metal angle bracket
1 - Suction cup
1 - Short panhead screw
2 - Short machine screws
2 - Nuts
2 - Washers
2 - Long panhead screws
1 - Safety rope
The two longer wood screws, if included, are for per-
manently mounting the transducer bracket to the boat. They
do not apply here.
The suction cup installs using the single short screw.
Attach it to the slot in the angle bracket. Center the verti-
cal adjustment and tighten
the screw until the suction
cup can no longer rotate.
Note - The small fin at the
edge of each cup is meant to
help you remove the cup
from the surface it is stuck
to.
Figure 5
5