Vexilar LC-10 - Manual (Page 7)

may need to purchase
the optional Tri-Cup
bracket shown in figure
6.
ALTERNATE
TRANSDUCER
MOUNTING
If you choose not to use the suction cup mounting
method, you can permanently mount the transducer to
your boat. This can, often, give better results, but you will
lose the portability of the transducer.
TRANSOM MOUNTING
The LC-10 transducer can be mounted, permanently,
on the transom of the boat. Proper installation will allow
a clear depth reading at any boat speed. Attach the angle
bracket to the transducer (flat edge facing forward). Locate
a spot at the bottom of the transom that is clear of ribs and
rivets that would be just in front of the transducer. Hold it
up to the boat. Mark the first hole on the transom, or mount-
ing plate, so that when the bottom of the transducer is flush
with the bottom of the boat, the hole is located at the bot-
tom of the bracket slot. This gives you room to "fine tune"
the position of the transducer and optimize your reading
after you've put the back boat in the water.
7
Figure 6