Winco DPG-2145-001 - Manual (Page 13)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 5
Chapter 3.
Parameter Reference
This chapter provides information regarding each of the parameters that can
be adjusted when a computer is connected to the controller via the COMM
port. Universal PST (described in the following chapter) is required to make
adjustments to the parameters described in this chapter, with the exception
of Set Speed A, Set Speed B, and OVG @ Set Speed A. It contains 29
subsections. Each subsection provides information about a single parameter.
The following tables list each of the parameters and their default, minimum,
and maximum values. Several of the parameters have minimum and
maximum values set by other parameters. Speed and Rate values are shown
as Hertz values.
The parameter list provides information regarding each of the parameters that
can be adjusted when a computer is connected to the controller via the COMM
port and the Universal PST software. The COMM port is intended only for
configuration and periodic service. Do not leave a computer and/or COMM
cable connected to the COMM port.