Winco DPG-2145-001 - Manual (Page 14)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 6
DPG-2101-00X & DPG-2146-00X Parameter List
PARAMETER LIST FOR DPG-2101-00X (MPU) & DPG-2146-00X (IGNITION )
(These controllers use the 7-terminal Euro style screw terminal connector.)
PARAMETER NAME DEFAULT MINIMUM MAXIMUM
Opt.
1. No. of Flywheel
Teeth or Pulses per
revolution
-001 0 0 0
-002 0 0 572
Req. 2. Set Speed A 1000 (25) Set Speed A Min Set Speed A Max
3. Not Available
Opt. 4. Idle Speed 50 (20) Idle Speed Min Idle Speed Max
Req. 5. Proportional 25 1 99
Req. 6. Integral 50 0 99
Req. 7. Derivative 25 0 99
Req. 8. OVG @ Set Speed A Use the controller’s built-in GAIN potentiometer
9. Not Available
Opt. 10. OVG @ Idle Speed 20 1 99
Req. 11. Gain Factor 20 (40) 1 99
Req. 12. Speed Filter 16 (4) 1 24
Opt. 13. Idle Hold Time 0 0 9999
Opt. 14. Accel Rate 1000 (3000) 1 9999
Opt. 15. Decel Rate 1000 (3000) 1 9999
Opt. 16. Startup Rate 1000 (3000) 1 9999
Opt. 17. Integral Low Limit 0 0 Integral High Limit
Opt. 18. Integral High Limit 99 Integral Low Limit 99
Opt. 19. Password 0 0 99
Opt.
20. Over Speed Limit
-001 100 0 100
-002 15000 (450) 0 15000 (450)
Opt. 21. Set Speed A Min 10 (2) 10 (2) Set Speed A
Opt. 22. Set Speed A Max 11000 (300) Set Speed A 11000 (300)
23. Not Available
24. Not Available
Opt. 25. Idle Speed Min 10 (2) 10 (2) Idle Speed
Opt. 26. Idle Speed Max 11000 (300) Idle Speed 11000 (300)
Opt. 27. Duty Cycle Limit 95 10 95
Req. 28. Startup Speed 1000 (25) 10 (2) 11000 (300)
Opt. 29. Startup Duty Cycle 30 5 95
Req. = Parameter adjustment required to achieve Basic Governing
Opt. = Parameter use is optional
Default, Minimum and Maximum values in parenthesis apply when the controller uses ignition pulses to
sense engine speed, which would be the case for a DPG-2146-00X controller
Note: All Speed and Rate values are shown as Hertz values (parameters 2, 4, 14-16, 20-22, 25-
26). Changing the value of parameter 1 will cause different default values to be displayed based
on the Hertz to RPM formula.