Winco DPG-2145-001 - Manual (Page 28)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 20
Installing Universal PST
Instructions to Install from CD-ROM:
When you insert the DPG Software Calibration Kit’s CD-ROM into your computer,
the ―autorun‖ file on the CD will attempt to launch the ―setup.exe‖ program. If the
―autorun‖ feature is disabled on your computer or does not start the setup program
you can launch the program manually. To start the installation manually, explore
the contents of the CD then double click on
the ―setup.exe‖ file.
Instructions to Install from the Downloaded File:
The file downloaded from the Woodward web site contains two files:
―ReadMeFirst.txt‖ and ―setup.exe‖. Run the downloaded file to extract its contents
to a folder you choose on your
computer’s hard drive. Then run the ―setup.exe‖
program from the folder you extracted it to.
IMPORTANT:
The installation program will detect operating system components older than those
required by the "Universal PST" application. In this case the installation program
will ask if you want to update Windows. If you do not want "setup" to update your
system then you can not use the "Universal PST" application on this computer.
Read the setup program's instructions carefully as they appear and respond as
needed. The installation may take as long as 7 minutes depending on your
computer's power and operating system. Do not interrupt the installation program
even though it may appear as
though it is not running.
NOTE: Administrator rights may be needed to install on some Microsoft Windows
operating systems (such as Windows XP Professional) for the setup program to
properly register application resources.
Wiring the COMM Port to a PC
To construct a communications cable to use between the DPG’s COMM port and
your PC’s RS-232 serial port refer to the table and wiring diagram below.
Remote access via the COMM port is intended for
connection only while programming, tuning and
troubleshooting the control/engine. It is a service port and
not intended for permanent connection of a PC and/or cable.
RJ11 OR
RJ12
POSITION
DPG-21XX SIGNAL CONNECTS TO:
1 No connection N/C
2
Transmit data to PC
PC receive (RxD)
DB9 pin 2
3 Receive data from PC
PC transmit (TxD)
DB9 pin 3
4
COMMON
PC common
DB9 pin 5
5
+5 Vdc (Do NOT
connect at the PC end)
N/C
6 No connection N/C
1 2 3 4 5
6 7 8 9
1 2 3 4 5 6
DB9F
RJ11M