Winco DPG-2145-001 - Manual (Page 32)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 24
Parameter Help
To get help on a particular parameter, single click the left mouse button on a
p
arameter’s Value, then press <Ctrl><F1> on the computer’s keyboard.
<Ctrl><F1> means press and hold the <Ctrl> key while the <F1> key is pressed
and released. This opens the DPG online help file and automatically jumps to the
selected parameter’s help page.
NOTE: Complete online help for each DPG controller is also accessible by
selecting either
“Governor Help Contents” or “Parameter Definitions” from the
Universal PST Help menu.
Synchronizing Universal PST with a DPG
Pressing the <Read All> button will load the current values for all of a DPG-2XXX-
00X’s parameters into Universal PST. The <Read All> button is part of the Table
View.
IMPORTANT: If the communication cable is unplugged from a DPG and plugged
into a different DPG while the Universal PST application is still running, then the
<Read All> button must be pressed in order for Universal PST to synchronize with
the new DPG.
The <Write All> button is very useful when reusing saved setup data to configure a
new system with the same data as a previous one. Simply load an existing set of
previously saved parameter values into the Parameter Setup table using ―Open a
setup data file” from the File menu then press the <Write All> button.
Status View
The Status View panel is displayed only after pressing
the <View Status> button. The Status View panel is part
of the Table View display mode.
The Status View panel displays a table where each row
shows the Name of a read only parameter and its current
Value (when ―Auto Read is ON‖)
Press (left mouse click) the <START Monitoring> button
to have the Universal PST program automatically refresh
the Values. Press the <STOP Monitoring> button to
disable automatic refresh.